How to solve the problem of yellow water discharge of softening water equipment?

Softened water equipment is widely used in daily life, but sometimes its water will turn yellow, causing inconvenience to users. This situation may be caused by scale, iron oxide and other reasons caused by long-term operation of the equipment. However, there are steps we can take to address this problem.

First, you can try to clean the softened water equipment. Users can choose professional cleaning agents, according to the requirements of the manual cleaning, the equipment inside the scale and dirt clean, so as to improve the quality of water.

Secondly, a pre-filter can be added. Before the water enters the softened water equipment, adding a pre-filter can effectively block the impurities and dirt of large particles, reduce the burden of the equipment, and thus improve the quality of the effluent.

In addition, the operating parameters of the softened water equipment can also be adjusted appropriately. According to the local water quality and use situation, adjust the brine concentration, recovery rate and other parameters of the equipment, can achieve better softening effect and effluent quality.

Finally, the softened water equipment needs to be maintained regularly. Check the operating status of the equipment regularly, replace the filter element and Resin in time, clean the inside of the equipment, and prevent the scale and dirt caused by long-term use from affecting the quality of the water.
In short, the problem of yellow water of the softening water equipment is not without solution, through cleaning equipment, installing pre-filters, adjusting operating parameters and regular maintenance measures, we can effectively solve this problem and ensure the quality and safety of the water.